Description

The Dual Sta Level project is a high-end project from Drip Electronics based on the Vintage Sta Level compressor/limiter. The Dual Sta Level design is 2 channels in one case with all the best features and high-end design expected from Drip Electronics.  The PCB’s and support for this project are all handled through Drip Electronics.

This is just for the custom enclosure and front panel that was designed / spec’d and approved by Drip Electronics for this project.

FINISHES

The front panel is a Sta Level gray powder coat.  The rest of the enclosure is black powder coat.

ENCLOSURE DETAILS

1. MADE IN THE USA
2. 18 gauge metal cases
3. Rear panel cutouts to match Drip Electronics custom back panel needs.
4. Custom Drip Dual Sta Level front panel
5. 18″ deep
6. 17″ wide case
7. Vent holes on tops and sides.
   The side vent holes are spaces so that a internal divider bracket can be mounted to the case in various placements front to back of the case.
8. Internal Divider for mounting hardware to inside of the enclosure.
9. Clean outside for easy installation in racks
10. Ships flat for lower shipping cost

ENCLOSURE INCLUDES

• 1 top & bottom panel
• 1 rear panel
• 2 side panels
• 1 internal divider
• Custom Drip Dual Sta Level front panel

Recommended components:
All cutouts are per Drip Electronics direction and requirements.  Please refer to Drip for components that go along with this case.