Harrison Ford Filters

Harrison Ford Filters


The Harrison Ford Filter case is designed for 8 channels of the PCB’s that had been originally offered by Strange Weather studios over at the Prodigy forum. Since then Marc from Strange Weather has allowed us to continue to offer the boards along with our cases. The back panel is cut out with two DB25 holes for an input and output, star ground, and the IEC connector.

SKU: CC-HFF Categories: , Tag:


PCB’s: $15 USD for 8 channels with purchase of the case. PCB’s without the purchase of a case are 5 USD plus shipping per channel.

Kit (case purchased separate): $475 + shipping – Kits include parts for 8 channels: Knobs, Push botton caps, switches, pots, PCB’s, resistors, caps (Wima’s for the filters), IC’s, IC sockets, IEC inlet, DB25 connectors and Molex headers, crimps pins.  You need the case and front panel seprataley, the PSU and power lamp. 

Kit & Case Comb Sell:  $600 + Shipping


  1. Harrison Ford Filter case will be powder coated black.
  2. The faceplate is black and white silkscreen for the Harrison Ford Filter design.


  1. 18 gauge metal cases
  2. Rear Panel DB25’s, IEC, and Star Ground cutouts
  3. 9″ deep
  4. 17″ wide case
  5. Vent holes on tops and sides
  6. Clean outside for easy installation in racks
  7. Ships flat for lower shipping cost


  • 1 Faceplate
  • 1 Top & bottom panel
  • 1 Rear panel
  • 2 Side panels

DB25 – Tyco Electronics (Mouser Part # 571-5-747912-2)
IEC – Schurter 6200.2100 (Mouser Part # 693-6200.2100)
On/Off switch- (Mouser Part # 611-D102J12S217DQA)
For support look here: http://www.groupdiy.com/index.php?topic=46390.0

Additional information


Case and PCB's only, Case Only, Kit & Case Comb Sell, Kit


There are no reviews yet.

Be the first to review “Harrison Ford Filters”

Your email address will not be published. Required fields are marked *